5" Complete Liner Kit

5" Complete Liner Kit

5" Complete Chimney Liner Installation Kit.


More details

£214.00 tax incl.

Suitable for the Carron 4.7kW DEFRA Exempt stove, or any DEFRA Exempt stoves with a 5" flue outlet.

Our high quality Multifuel 316 Grade stainless steel flexible chimney flue liner 5" diameter. A complete installation / fitting kit consisting of:

  • The flexible liner in your chosen length (please select from the drop down options at the top of the page, see below for advice),
  • Adaptor to join to your stove pipe (5" stove pipe to 5" flexible liner)
  • Fire cement to seal up the joints at the bottom end of the system,
  • A nose cone / guider - that fits on the end of the liner during installation making it easier to pass down the chimney.
  • Cowl and fittings for the top of the chimney (please select type required, see below for advice).

What diameter of liner do I require?

For most stoves in the UK the liner diameter must be 6" to comply with Building Regulations (or larger if your stove flue oulet is greater than 6"), even for stoves with a 5" flue. 

However, if you have a DEFRA Approved stove (which you would require if burning wood in a smoke-control area) then a 5" flexible liner can legally be used if the stove has a 5" flue outlet, as does the Carron 4.7kW stove. 

What length of liner do I require?

The liner is sold by the metre. Measure the height from the point at which the liner will start (above the stove, at the top of your length of enamel flue pipe, see diagram) up to the top of the chimney (including the pot if it is present). Allow for any bend or offset in the chimney. A 2-storey house will typically require an 8m liner. (please note incorrectly ordered liners can not be returned as they are cut to order), a bungalow may typically require a 5 or 6m.

Which cowl option?

For houses that have no chimney pot at the top of the chimney stack (the original pots have often been removed on old houses), then you will normally use our "Top plate option". This consists of a steel top plate approx 400mmx400mm which will sit on top of the brick chimney stack (bed it down with cement), plus a clamp that will take the weight of the liner, plus the rain cap/cowl that sits on top. You can then flaunch around the cowl with cement. We also offer this option with a birdguard cowl, available in plain steel, black or terracotta colours.

If your chimney has a traditional round terracotta or clay pot on top and you intend to keep it then the liner can be fed down through the pot (as long as the opening is greater than 6" which it normally will be). In this case you only have one item at the top instead of three. This is called an All-In-One cowl, and will sit into the top of the pot and also take the weight of the liner. This is available in steel or in a special Anti-Down-Draught version which is terracotta in colour and will help prevent down draughts (useful if in an area where there are high winds etc.).

What other parts are needed for a stove installation?

Have a look at the diagram showing a typical installation. You will normally require a short length of the black enamel stove flue pipe e.g. 1m. Please see these here , plus the register / closure plate - a steel plate that fits across inside your chimney above the stove, see here. Once the liner is down the chimney you may wish to insulate it with Vermiculite. Insulating the flue will generally improve the draw.


No products

Shipping £0.00
Total £0.00

Check out